QUESTION 17
In order to set Site (chassis) priority per VS, following command should be used:

QUESTION 18
What is the difference between Dual-Site and Multi-Room?

QUESTION 19
Orchestrator should be defined in SmartConsole as:

QUESTION 20
What is the default range of physical ports for downlinks on Orchestrator MHO-140?

QUESTION 21
What is the default Distribution mode?

QUESTION 22
What is a Security Group?

QUESTION 23
What type of cluster can a Security Group can be compared to?

QUESTION 24
Which is a valid requirement for a supported Maestro appliance?

QUESTION 25
Which licenses should be issued for the Orchestrator?

QUESTION 26
How many orchestrators may Dual-Site include”

QUESTION 27
What kinds of transceivers are supported on Orchestrator MHO-140?

QUESTION 28
There is a Security group of 10 Appliances and all of them are up and running. How many Appliances within a Security Group keep the same connection in its connection table in case of NAT?

QUESTION 29
In case of Correction, where is information about Owner stored?

QUESTION 30
One single Appliance supports 1M concurrent connections. How many concurrent connections will support Security Group of 2 Appliances?

QUESTION 31
What is the default range of physical ports for downlinks on Orchestrator MHO-170?

QUESTION 32
In case of VSX: What is the right command to see overall performance details of all Appliances within the Security Group and all Virtual Systems?

QUESTION 33
There are two 10Gbps dual-port NIC installed on a 6800 appliance. Which interfaces should be connected to Orchestrator 1 for downlinks’ intra-orchestrator redundancy when using two Orchestrators?

QUESTION 34
On MHO-170 – In default configuration, what are GAIA names of Security Group Management ports?

QUESTION 35
What is the basic installation sequence of the Orchestrator in case of single Orchestrator?
1. Create a Security Group
2. Configure Default Gateway
3. Connect with Serial Console cable to the Orchestrator
4. Configure IP for one of its Management interfaces
5. Connect an appliance to a downlink port
6. Change Orchestrator amount to 1
7. Browse to the Orchestrator’s WebUI

QUESTION 36
What is a downlink interface used for?

QUESTION 37
There’s a 23800 appliance with quad NIC in slot 5. What would be the name of port 3 on this NIC?

QUESTION 38
What kind of cluster Dual-Site can be compared to?

QUESTION 39
What cannot be learned from the output of asg perf -v -p command?

QUESTION 40
What is the maximum amount of Appliances within Security group in Dual-Site configuration?