NEW QUESTION 59
Refer to the exhibit.

A BIG-IP Administrator configures a now VLAN on an HA pair of devices that does NOT yet have any traffic. This action causes the assigned traffic group to fail over to the standby device.
Which VLAN setting should be changed to prevent this issue?

NEW QUESTION 60
A BIG-IP Administrator finds the following log entry after a report of user issues connecting to a virtual server:
01010201: 2: Inet port exhaustion on 10.70.110.112 to 192.28.123.250:80 (proto 6) How should the BIG-IP Administrator modify the SNAT pool that is associated with the virtual server?

NEW QUESTION 61
A BIG-IP Administrator applied the latest hotfix to an inactive boot location by mistake, and needs to downgrade back to the previous hotfix.
What should the BIG-IP Administrator do to change the boot location to the previous hotfix?

NEW QUESTION 62
A virtual server at 10.10.1.100:80 has the
rule listed below applied. when HTTP_REQUEST { if {[HTTP::uri] ends_with “htm” } { pool pool1 } elseif {[HTTP::uri] ends_with “xt” } { pool pool2 } If a user connects to http://10.10.1.100/foo.txt which pool will receive the request.

NEW QUESTION 63
Which statement is true about the synchronization process, as performed by the Configuration Utility or by typing b config sync all?

NEW QUESTION 64
A BIG-IP Administrator opens a case with F5 Support. The support engineer requests the BIG-IP appliance chassis serial number.
Which TMSH command will provide this information?

NEW QUESTION 65
Which action will take place when a failover trigger is detected by the active system.

NEW QUESTION 66
A site has assigned the ICMP
monitor to all nodes and a custom monitor, based on the HTTP template,
to a pool of web
servers. The HTTPElbased monitor
is working in all cases. The ICMP monitor is failing for 2 of the pool member 5 nodes. All other settings are default. What is the status of the monitor is working in all cases. The ICMP monitor is failing for 2 of the pool member. 5 nodes. All other settings are default. What is the status of the pool members.

NEW QUESTION 67
Refer to the exhibit.


A BIG-IP Administrator creates a new Virtual Server to load balance SSH traffic. Users are unable to log on to the servers.
What should the BIG-IP Administrator do to resolve the issue?

NEW QUESTION 68
Assuming there are open connections through an active system’s NAT and a fail over occurs, by default, what happens to those connections?

NEW QUESTION 69
When configuring a pool member’s monitor, which three association options are available. (Choose three.)

NEW QUESTION 70
A BIG-IP Administrator notices that one of the servers that runs an application is NOT receiving any traffic. The BIG-IP Administrator examines the configuration status of the application and observes the displayed monitor configuration and affected Pool Member status. What is the possible cause of this issue?

NEW QUESTION 71
Which two can be a part of a pool’s definition. (Choose two.)

NEW QUESTION 72
A BIG-IP Administrator needs to have a BIG-IP linked to two upstream switches for resilience of the external network. The network engineer who is going to configure the switch instructs the BIG-IP Administrator to configure interface binding with LACP. Which configuration should the administrator use?

NEW QUESTION 73
A BIG-IP Administrator is performing maintenance on the active BIG-IP device of an HA pair. The BIG-IP Administrator needs to minimize traffic disruptions.
What should the BIG-IP Administrator do to start the maintenance activity?

NEW QUESTION 74
How is persistence configured.

NEW QUESTION 75
Assuming other failElover settings are at their default state, what would occur if the failElover cable were to be disconnected for five seconds and then reconnected.

NEW QUESTION 76
Which process or system can be monitored by the BIG-IP system and used as a failover trigger in a redundant pair configuration?