Q97. Which item is MOST commonly used when installing horizontal cabling above a suspended ceiling with no dedicated cable tray or J-hook support?

Q98. For a telecommunications grounding and bonding system, which bonding conductor is typically responsible for ensuring that all metallic pathways and equipment within a building’s telecommunications spaces are at the same ground potential?

Q99. Which type of cabling is installed between a main cross connect and a horizontal cross connect?

Q100. What is the primary difference between an Equipment Rack and a Cabinet, as referenced in BICSI documentation?

Q101. Which of the following items may be used as a substitute device for a pulling eye?

Q102. The information transmitted by an ICT system can originate in two fundamental forms:

Q103. Which of the following is used to connect cabinets to the nearest SBB?

Q104. When labeling patch panels, which of the following is MOST aligned with TIA-606 and BICSI best practices?

Q105. Which type of optical fiber cable should be color coded with a RED outer cable sheath?

Q106. Which of the following refers to a set of rules issued by a governmental body at the state level within the US?

Q107. What is the specified performance level for Category 6 cable?

Q108. What is the maximum allowable horizontal cable length?

Q109. What is the characteristic impedance of Series-6 coaxial cable?

Q110. Which of the following topologies is the recommended topology for distribution systems in campus environments?

Q111. The horizontal distance from the base of the ladder to the supporting wall should be ____ percent the working length of the ladder.

Q112. Which of the following markings is used for non-conductive optical fiber general-purpose cables?

Q113. When specifying cable routing within an Equipment Room (ER), BICSI guidelines recommend that ladder racks be mounted with adequate clearance from the top of the equipment racks. What is the TYPICAL recommended vertical clearance?

Q114. Two truck drivers are communicating over a Citizens Band (CB) radio. Only one driver can send a message at a time with this system.
What type of transmission method is used in this example?

Q115. A cross-connect in the Telecommunications Room uses 110-blocks. Which parameter is MOST important to verify after performing cross-connects?

Q116. Which is a keyed, contact, moderate loss connector in present use today that is pull & wiggle-proof?

Q117. Which of the following is a benefit of air-blown optical fiber cable?