100% Pass Guaranteed Accurate JN0-352 Answers 365 Days Free Updates [Q82-Q97]

Rate this post

100% Pass Guaranteed Accurate JN0-352 Answers 365 Days Free Updates

JN0-352 DUMPS Q&As with Explanations Verified & Correct Answers

Juniper JN0-352 Exam Syllabus Topics:

Section	Objectives
Topic 1: Operations and Troubleshooting	– Junos CLI monitoring tools – Troubleshooting routing and switching issues
Topic 2: High Availability	– VRRP configuration and behavior – Redundancy concepts in enterprise networks
Topic 3: Routing Protocols	– IS-IS overview – BGP fundamentals and policy control – OSPF configuration and troubleshooting
Topic 4: Routing Policy and Filtering	– Route filtering and preference control – Policy statements
Topic 5: Layer 2 Switching Technologies	– Ethernet switching concepts – Spanning Tree Protocol (STP/RSTP/MSTP) – VLANs and trunking
Topic 6: Network Services	– Basic multicast concepts – NAT concepts in Junos

NO.82 Which statement is correct about IP-IP tunnels?

IP-IP tunnels only support encapsulating IP traffic.

IP-IP tunnels only support encapsulating non-IP traffic.

The TTL in the inner packet is decremented during transit to the tunnel endpoint.

There are 24 bytes of overhead with IP-IP encapsulation.

NO.83 Which statement is correct about the configuration shown in the exhibit?

The configuration will not complete the commit check process and will error out.

The ge-0/0/0 and ge-0/0/1 interfaces are operating in trunk mode.

All three interfaces are operating in access mode.

The ge-0/0/2 interface is operating as a Layer 3 interface.

NO.84 Referring to the exhibit, which router will become the OSPF BDR if all routers are powered on at the same time?

NO.85 You are combining two existing interfaces into a single LAG interface, but you do not see the LAG interface being created. Which two actions are required to solve this problem? (Choose two.)

Ensure that the first LAG interface name is ae1.

Ensure that LAG is enabled on the chassis.

Ensure that LAG is enabled on each member interface.

Ensure that the first LAG interface name is ae0.

NO.86 You are troubleshooting a BGP routing issue between your network and a customer router and are reviewing the BGP routing policies. Which two statements are correct in this scenario?
(Choose two.)

Export policies are applied to routes in the RIB-ln table.

Import policies are applied to routes in the RIB-Local table.

Import policies are applied after the RIB-ln table.

Export policies are applied after the RIB-Local table.

NO.87 Which statement is correct about GRE tunnels?

The time-to-live field in the tunnel payload is decremented during transit.

GRE tunnels only support encapsulating non-IP traffic.

There are 20 bytes of overhead with GRE encapsulation.

GRE tunnels only support encapsulating IP traffic.

NO.88 What determines the preferred route to a destination in an IS-IS network?

the path that passes through a Level 2 router closest to the destination

the path that has the lowest accumulated metric value

the path that has the most recently originated LSP

the path that has the highest accumulated metric value

NO.89 Your GRE tunnel is not transitioning to the Upstatus. What would be the first step in troubleshooting the problem?

Verify tunnel endpoint reachability.

Verify that the status of the management interface is up.

Verify the status of the management routing instance.

Verify that the routing instance for GRE tunnels is created.

NO.90 What is the default keepalive time for BGP?

10 seconds

60 seconds

30 seconds

90 seconds

NO.91 You need to block SSH (TCP port 22) traffic from the 192.168.10.0/24 network.
Which firewall filter term is correct in this scenario?

term block-ssh { from { source-address 192.168.10.0/24; service ssh; } then reject; }

term block-ssh { from { source-address 192.168.10.0/24; protocol tcp; destination-port 22; } then discard; }

term block-ssh { from { destination-address 192.168.10.0/24; protocol tcp; destination-port 22; } then discard; }

term block-ssh { from { source-address 192.168.10.0/24; protocol tcp; source-port 22; } then discard; }

NO.92 Which statement describes how a generated route determines its next hop?

It uses the next hop of the first contributing route.

It uses a static next hop configured under the aggregate route hierarchy.

It uses the next hop of the least-specific contributing route.

It uses the next hop of the primary contributing route.

NO.93 You want to verify prefix information being sent from 10.36.1.4.
Which two statements are correct about the output shown in the exhibit? (Choose two.)

The routes displayed have traversed one or more autonomous systems.

The output shows routes that were received prior to the application of any BGP import policies.

The output shows routes that are active and rejected by an import policy.

The routes displayed are being learned from an I BGP peer.

NO.94 You have traffic for a video streaming application traversing a GRE tunnel in your network and users are reporting poor performance. Both ends of the tunnel are using the default settings for a gigabit Ethernet interface, but you observe excessive packet drops due to exceeding the MTU.
Which two steps would you take to improve connectivity for this application? (Choose two.)

Increase the MTU for the member interfaces to 1524 bytes.

Route the GRE tunnel through a higher bandwidth link.

Configure the clear-dont-fragment option on the member interfaces.

Increase the MTU for the member interfaces to 1500 bytes.

NO.95 You are establishing a new BGP session to an EBGP peer using loopback addresses.
In addition to your general EBGP settings, which BGP feature must be enabled for this session to establish?

multihop

multipath

damping

passive

NO.96 You are troubleshooting a Layer 2 topology issue in a campus network. The switches are running RSTP. You need to verify which switch is currently acting as the root bridge and identify the root port on the local device.
Which operational command should the administrator use to view this information?

show spanning-tree interface

show spanning-tree bridge

show ethernet-switching table

show ethernet-switching interface

NO.97 Which statement about aggregate routes is correct?

Aggregate routes can only be used for static routing but not for dynamic routing protocols.

Aggregate routes are automatically generated for all of the subnets in a routing table.

Aggregate routes are always preferred over more specific routes, even when the specific routes have a better path.

Aggregate routes are used for advertising summarized network prefixes.

JN0-352 dumps Exam Material with 149 Questions: https://www.troytecdumps.com/JN0-352-troytec-exam-dumps.html

High-quality Troytec review files

100% Pass Guaranteed Accurate JN0-352 Answers 365 Days Free Updates [Q82-Q97]

Juniper JN0-352 Exam Syllabus Topics:

troytecdumps

Leave a Reply Cancel reply

Juniper JN0-352 Exam Syllabus Topics:

Related Posts

Valid ISC Certification CGRC Dumps Ensure Your Passing [Q288-Q303]

Free 2026 CDMP MD-1220 dumps are available by TroytecDumps [Q53-Q77]

[Aug 17, 2026] Get to the Top with CCFA-200b Practice Exam Questions [Q17-Q34]

troytecdumps

Leave a Reply Cancel reply