QUESTION 141
Two machines are to be compared. A sample of 100 pieces of manufactured product is taken from each machine and their measurements recorded each shift. The most appropriate control chart to compare the results from the two machines over time is an:
Response:

QUESTION 142
A noncontact measuring instrument that gages an object’s temperature by measuring its self-emission and emissivity is called which of the following?
Response:

QUESTION 143
A machine vision inspection system would not be useful for which of the following applications?
Response:

QUESTION 144
What type of testing can determine internal defect and requires a couple material such as water of glycerine?
Response:

QUESTION 145
Calculate the mode of the following data set: 3 4 5 6 6 6 7 3 2 7 8 7 8 8 8 8 9 Response:

QUESTION 146
Which of the following regarding random sampling is a standard norm?
Response:

QUESTION 147
The print call out for a general purpose internal thread would include
Response:

QUESTION 148
Which of the following is a disadvantage of sampling plans?
Response:

QUESTION 149
Which of the following are advantages of automated inspection?
I) Fatigue reduction
II) Increased variation of results
III) Increased inspection points
Response:

QUESTION 150
Identify the correct statement about the profilometer.
Response:

QUESTION 151
A system is best defined as
Response:

QUESTION 152
Which of the following hardness tests is best suited for plastic and rubber?
Response:

QUESTION 153
Using an optical flat to determine flatness requires specific conditions. Which of the following is one of those conditions?
Response:

QUESTION 154
Seriousness classifications for quality characteristics and defects are derived from Response:

QUESTION 155
If the capability index (Cp) of a process is less than 1.00, this generally means:
Response:

QUESTION 156
When there is an even number of values listed in descending order, the median is represented by which of the following?
Response:

QUESTION 157
You are performing a Gage R&R study using electronic micrometers. The display is X.XXXX and the last digit is either a zero or a five. You read the manual that comes with the gage and it indicates that it is accurate to .00002″.
Assuming that the tool is sufficiently accurate, how should you perform your study?
Response:

QUESTION 158
During what audit type would the client be more likely not to ignore problems found outside the audit scope?
Response:

QUESTION 159
Plug gages and ring gauges have which of the following in common?
Response:

QUESTION 160
What is the total tolerance of a blueprint dimension that reads 3″ .002″?
Response: