QUESTION 30
Which product, is used in conjunction with other coatings such as FBE when the lines run through wetlands or a body of water?

QUESTION 31
You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

QUESTION 32
A single component water borne acrylic coating cures by:

QUESTION 33
When performing inspection in accordance with ASTM D 4138 the Inspector will use:

QUESTION 34
When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

QUESTION 35
You are the NACE Level 2 Coating Inspector where SSPC PA 2 has been specified with an additional requirement that no individual gauge reading shall be below a certain value.
As this is not part of the standard you should:

QUESTION 36
Which product, when closely inspected has a green or red layer of fusion bonded epoxy (FBE) that is visible directly on the steel?

QUESTION 37
You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

QUESTION 38
Eddy current DFT gauges are used to measure Dry Film Thickness in which of the following situations:

QUESTION 39
As a NACE Level 2 Inspector on a field job; prior to submission your documentation should always reviewed and approved by:

QUESTION 40
The primary purpose of Fireproofing coatings are to provide:

QUESTION 41
Dehumidification is defined as the removal of moisture vapor from the air to

QUESTION 42
Examples of non-ferrous metals include
Select All that Apply:

QUESTION 43
You are the NACE Level 2 Inspector on a project where overcoating of galvanized steel is being performed. The specification references SSPC SP 16 as the surface preparation method. At the pre-job meeting operations personnel make it clear that abrasive blasting will not permitted. The Owner’s representative asks you what other methods might be used.
Of the options shown below, what would be the preferred option in this situation?

QUESTION 44
In which type of concrete are laitance commonly encountered?

QUESTION 45
When performing testing in accordance with ASTM D 2583 the inspector may observe:

QUESTION 46
Inspection and Test Plans are provided to:

QUESTION 47
All of these are advantages of using repair patches EXCEPT