QUESTION 24
During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

QUESTION 25
What is the required distance between a CPE and a gNodeB in a 5G network test?

QUESTION 26
According to 5G eMBB service requirements, which of the following is the minimum rate required for network edge coverage?

QUESTION 27
Which type of information about NR cells is carried in the neighboring NR cell MRs reported by UEs?

QUESTION 28
Which of the following NR channels or signals supports static and dynamic power control?

QUESTION 29
Which of the following actions are involved in NAS procedure management in 5G?

QUESTION 30
On an NSA network, the eNodeB immediately triggers the SgNB addition procedure after a UE attaches to the LTE network. If the SgNB addition fails, the eNodeB attempts to add the SgNB again until it is successful.

QUESTION 31
Which of the following actions are involved in NAS procedure management in 5G? (Choose all that Apply)

QUESTION 32
Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

QUESTION 33
Which of the following NR channels or signals supports static and dynamic power control?

QUESTION 34
E2E network device update is required for the evolution from 5G NSA networking to SA networking.

QUESTION 35
The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

QUESTION 36
An NR CQI value represents a coding scheme and coding efficiency. How many bits does a CQI value reported by a UE have?

QUESTION 37
Which of the following files must be prepared when remotely commissioning a gNodeB using the MAE Deployment? (Choose All that Apply)

QUESTION 38
During single site verification, which of the following messages can be traced by the Probe to analyze problems?

QUESTION 39
In the inter-site DC solution, the X2 interface can be used to implement transmission interconnection between the LTE and NR sites. Which of the following is the requirement of the transmission delay in such case?

QUESTION 40
If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, which of the following route configurations is more suitable?

QUESTION 41
The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

QUESTION 42
Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

QUESTION 43
In the inter-site DC solution, the X2 interface can be used to implement transmission interconnection between the LTE and NR sites. Which of the following is the requirement of the transmission delay in such case?